ADC0808 PDF

The ADC IC is a commonly used ADC module for projects were an external ADC is required. Find ADC pin diagram, features & datasheet. ADC – A/D converters, used to convert analog signal to digital signals, like ADC IC, ADC IC, pin configurations and interfacing with microcontroller . The ADC/ADC is an 8 bit ADC that also contains an 8 channel multiplexer. The FPGA used in this case was the Altera 10k20RC that is found on.

Author: Yozshuzahn Vudoshakar
Country: South Africa
Language: English (Spanish)
Genre: Automotive
Published (Last): 18 February 2007
Pages: 122
PDF File Size: 4.66 Mb
ePub File Size: 4.77 Mb
ISBN: 434-2-25637-605-4
Downloads: 86647
Price: Free* [*Free Regsitration Required]
Uploader: Tusho

8051 – ADC0808 Interfacing

Note that it can take up to 2. Skip to main content. Begin by downloading the files into acc0808 desired destination directory and then compile them in this order.

Connect to ground of the circuit. Clock The clock signal afc0808 required to cycle through the comparator stages to do the conversion. In present time there are lots of microcontrollers in market which has inbuilt ADC with one or more channels.

Then microcontroller shows its value at Ch1 position in LCD. This means that an entire conversion takes at least 64 clock cycles.

Like the ALE pulse the minimum wdc0808 width is ns. And like wise for other channels. When the conversion is complete the EOC pins goes low to indicate the end of conversion and data ready to be picked up. There are a couple of limitations that follow: Signal from the ADC.

The input which is to be converted to digital form can be selected by using three address lines. The voltage level that, when received as an input, will output “” to the FPGA. aec0808

Analog to Digital Converter – ADC/ADC

Source code The source code consists of a few of files. Start conversion; input pin; a low to sdc0808 pulse is given. Or even to use as a standalone ADC module. Address Lines Because the chip has an 8 channel multiplexer there are three address select lines: The ALE should be pulsed for at least ns in order for the addresses to get loaded properly. Once loaded the multiplexer sends the appropriate channel to the converter on the chip.

And the formula for radiometric conversion is given by: Some external ADC chips are ,, and there are many more. Be sure to consult the manufactures data-sheets for other chips. Top rail of Reference voltage. Vref is connected to ground normally.

That is because ADCs require clocking and can contain control logic including comparators and registers. I have made small changes to the original code. I have changed some modifications too but acc0808 its not working. Interface SD Card with Arduino.

IC ADC0808

And here we have used three potentiometers connected at pin 26, 27, and 28 of ADC And then ADC reads selected channel and send output to microcontroller. Has to be given clock signals 0V-5V 20Mhz approx.

Table 2 provides a summary of all of the input and output to the chip. Digital output bit 4. Hence, if you are looking for a ADC module with a decent avc0808 of 8-bit that could measure up to 8 channels then this IC is for you. This means it must remain stable for up to 72 clock cycles. Once the channel is set it should be enabled by making the Address latch enabled ALE pin to go high momentarily.

That is for every increase of A, B, and C. You can easily find them in Code. End of Conversion EOC. Adc00808 can be tied to the Start line if the clock is operated under kHz.