ArcWear performs vertical flame testing for textiles in accordance with ASTM D which is used in ASTM F, ASTM F, and NFPA We will report. 23 Jul Some updates have been made to ASTM D Standard Test Method for Flame Resistance of Textiles (Vertical Test) commonly used in flame. ASTM D Test Method for Flame Resistance of Textiles. (Vertical Test). • Pass criteria: max char length of 10 cm. • After-flame of not more than 2 seconds.
|Published (Last):||9 December 2009|
|PDF File Size:||3.56 Mb|
|ePub File Size:||4.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
The astm d6413 precision of this test method has not been established. Save my name, email, and website in this browser adtm the next time I comment.
Nfpa – astm d vertical flame test method
Tyndale performs voluntary safety auditing on Tyndale garment fabrics. Your email address will not be published. astm d6413
Afterglow astm d6413 the number of seconds during which there is a visible glow remaining on the fabric. The values stated in each system may not be exact equivalents; therefore, astm d6413 system shall be used independently of the other.
Astm d6413 D is used to determine flame resistance astm d6413 fabrics used to protect against astk electric arc and flash fire hazards. The purpose of this test is to determine whether a fabric will continue to burn after xstm source of ignition is removed. As a minimum, astm d6413 test samples used should be as homogeneous as possible, that are drawn from the material from which the disparate test results are obtained, and that are assigned randomly in equal numbers to each laboratory for testing.
The ASTM D test method is utilized to evaluate the flame resistance of every production lot of fabric used in Tyndale-branded clothing.
The occurrence of melting or dripping, if any, is astm d6413 recorded. Link to Active This link will always route to the current Active version of the standard.
astm d6413 Adopted from Federal Test Standard No. Notify me of new posts by email. Work Item s – proposed revisions of this standard. Historical Version s – view previous versions of standard. The test results from the two laboratories should be compared astm d6413 a statistical test for unpaired data, at a probability level chosen prior to the testing series. The astm d6413 edge of the fabric axtm the bottom is exposed to a controlled methane flame for 12 seconds as seen in the image above, left.
Other materials with established test values may be used for this purpose. Astm d6413 is the responsibility of the user of this standard to establish appropriate safety and health astm d6413 and determine the applicability of regulatory limitations prior to use.
Combining values from the two systems may result in non-conformance with the standard. If astm d6413 bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration on the known bias. We are Proud to Protect workers, and understand that our dedication to testing is the only way to ensure that our garments perform as expected — every time!
Garments that meet astm d6413 standards are used to comply with: Char Length is the length in inches of fabric destroyed by the flame.
ASTM D6413: Vertical Flame Test for Flame Resistance of Textiles
This is the defining test method for compliance with OSHA July 10, at 9: After exposure to the flame, afterflame, afterglow and char length are measured: Referenced Documents purchase separately The documents listed below are referenced within the subject astm d6413 but are not provided as part of the standard.
Leave a Reply Cancel reply Your email address will not be published. Afterflame is the number of seconds during which there is a visible flame remaining on the astm d6413. Refer astm d6413 Section 14 for single-laboratory precision.
Notify astm d6413 of follow-up comments by email. Dd6413 tests are performed and the results are averaged and reported as the final test result. ICS Number Code